Talk:Hybrid transformer

Electronics Mid‑importance

	Electronics portal This article is part of WikiProject Electronics, an attempt to provide a standard approach to writing articles about electronics on Wikipedia. If you would like to participate, you can choose to edit the article attached to this page, or visit the project page, where you can join the project and see a list of open tasks. Leave messages at the project talk pageElectronicsWikipedia:WikiProject ElectronicsTemplate:WikiProject Electronicselectronic articles
Mid	This article has been rated as Mid-importance on the project's importance scale.

Electrical engineering

	Engineering portal This article is within the scope of WikiProject Electrical engineering, a collaborative effort to improve the coverage of Electrical engineering on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.Electrical engineeringWikipedia:WikiProject Electrical engineeringTemplate:WikiProject Electrical engineeringelectrical engineering articles
???	This article has not yet received a rating on the project's importance scale.

Telecommunications

	Telecommunication portal This article is within the scope of WikiProject Telecommunications, a collaborative effort to improve the coverage of Telecommunications on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.TelecommunicationsWikipedia:WikiProject TelecommunicationsTemplate:WikiProject TelecommunicationsTelecommunications articles
???	This article has not yet received a rating on the project's importance scale.

Hybrid coil circuit diagram.[edit]

...I'm very familiar with RF transformers, but I'm still not sure how the system being described in this article works. --Christopher Thomas (talk) 05:54, 20 August 2008 (UTC)[reply]

I've read the article and I also still don't fully understand how this device works. Here's a basic schematic of a hybrid coil[1] which helped me. The magic appears to be in opposing windings which prevent (cancel) signals from passing between transmit and receive terminals. --Kvng (talk) 16:44, 2 September 2008 (UTC)[reply]

This helps a bit, thanks. --Christopher Thomas (talk) 04:43, 5 September 2008 (UTC)[reply]

Based on request above, I added the wiring diagrams for hybrid coils. But these are obsolete, replaced by resistor networks and IC circuits. The diagrams are of historical interest.LoopTel (talk) 13:17, 1 November 2008 (UTC)[reply]

Thank you kindly, and yes, the article says it's obsolete for audio frequencies. It isn't so clear about RF hybrids, however. Jim.henderson (talk) 05:02, 6 November 2008 (UTC)[reply]

I have an ITT-2500 phone on my desk with a real transformer-based hybrid in it. It's an old style of phone, but new (2009) manufacture. 69.63.60.29 (talk) 00:24, 2 March 2009 (UTC)[reply]

Thank you for the wiring diagram! (I was about to ask what would happen if you were to use diodes instead of transformers to isolate input and output from each other. Then I got the answer to my own question. It wouldn't work.) 71.178.188.29 (talk) 23:30, 12 February 2014 (UTC)[reply]

...Sure that Hybrid_integrated_circuit describes the thing you expect it to describe? —Preceding unsigned comment added by 87.79.35.60 (talk) 12:48, 16 February 2009 (UTC)[reply]