File:Mine-Control-Panel.jpg

Summary

This photo is from "Training Manual TM 2160-20 Submarine Mining," U.S. War Department, Washington, D.C., October 15, 1930, p. 76.

It shows a control panel for a group of 19 submarine mines. In modern terms, this would be called a rack-mount module, which was mounted on 6 foot-tall, 24 inch-wide iron frame, called an operating board (which we today would call a rack), together with a signal block and a terminal bar. One each of these components was needed to control a single group of mines.

Briefly put, the control panel mounted a selector (visible at upper left of the panel), which, in tandem with a similar device in the underwater distribution box, sent signals from the mine group indicating when a mine was tipped by a passing ship and back to the mines from the mine casemate indicating when an individual mine was to be detonated. The panel held a bank of 20 push-button switches for firing individual mines in the group. After a mine was fired, its switch could be depressed and rotated such that it remained depressed and could not be pressed again until it was reset.

The panel also mounted switching relays to put the mine group in or out of firing mode (a safety precaution), or to place the mines in the group on contact firing status, in which they would detonate automatically if they were tipped past an angle of 45 degrees from vertical.

Since the most busy mine casemate in Boston Harbor (for example) controlled 15 mine groups (285 mines), it would have mounted 15 of these mine control panels, plus many more related rack-mount devices for controlling the casemate's generators, inverters, and battery systems.

Licensing

	This work is in the public domain in the United States because it is a work prepared by an officer or employee of the United States Government as part of that person’s official duties under the terms of Title 17, Chapter 1, Section 105 of the US Code. Note: This only applies to original works of the Federal Government and not to the work of any individual U.S. state, territory, commonwealth, county, municipality, or any other subdivision. This template also does not apply to postage stamp designs published by the United States Postal Service since 1978. (See § 313.6(C)(1) of Compendium of U.S. Copyright Office Practices). It also does not apply to certain US coins; see The US Mint Terms of Use.
This file has been identified as being free of known restrictions under copyright law, including all related and neighboring rights.

https://creativecommons.org/publicdomain/mark/1.0/PDMCreative Commons Public Domain Mark 1.0falsefalse